Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I think the @tinkergnome firmware for all machines is all based on one source, so it would not surprise me if the UM2 version also has the new 115c limit (did not try it).
Regarding the correction for the geared feeder no need to correct using flow, if you use the tinkergnome firmware you can just set the e-steps and your done.
e steps UM2+ feeder with new feeder motor: 369
e steps UM2+ feeder with old UM2 motor : 738
e steps UM2 (old feeder) : don't know (my machines are upgraded) but if you have the UM2 you can just read it out in the tinkergnome firmware.
the hex files are the packed firmware, ready to install, use cura 15.xx and select install custom firmware. make sure to take the correct one for your machine.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
I'm excited because I've personally produced this showcase event, so if you are curious what else I'm up to nowadays, come check it out and say hi in the chat! It would mean a lot!
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.
Recommended Posts
ultiarjan 1,215
I think the @tinkergnome firmware for all machines is all based on one source, so it would not surprise me if the UM2 version also has the new 115c limit (did not try it).
Regarding the correction for the geared feeder no need to correct using flow, if you use the tinkergnome firmware you can just set the e-steps and your done.
e steps UM2+ feeder with new feeder motor: 369
e steps UM2+ feeder with old UM2 motor : 738
e steps UM2 (old feeder) : don't know (my machines are upgraded) but if you have the UM2 you can just read it out in the tinkergnome firmware.
you'll find the firmware here;
https://github.com/TinkerGnome/Ultimaker2Marlin/releases
Link to post
Share on other sites