Jump to content

Cura 2.3 Infill issue for new patterns: Cubic and Tethraedral

Tolly

By Tolly
in UltiMaker Cura

 Share

Recommended Posts

Tolly

Tolly 0

Posted
Posted · Cura 2.3 Infill issue for new patterns: Cubic and Tethraedral

New infill patterns in Cura 2.3 are Cubic and Tethraedral.

Good! Since they breaks continuity of infill holes in Z axis.

But there is a transposition between them:

If we chosse "Cubic" then tethraedral is printed.

If we choose "Tethraedral" then Cubic is printed.

This transposition can be checked in layer view (layer view matches the printed piece).

    • Link to post
    Share on other sites
    • 1 month later...
    bagel-orb

    bagel-orb 61

    Posted
    Posted · Cura 2.3 Infill issue for new patterns: Cubic and Tethraedral

    I think you are mistaken. It's quite hard to see the 3d pattern by just looking at 2d layers.

    The cubic pattern has triangles / hexagons on each layer, while tetrahedral has 4 regular spaces line grids in two directions. (The two line grids in the same direction sway back and forth)

    Did this answer your question?

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • Introducing the UltiMaker Factor 4

        Introducing the UltiMaker Factor 4

        ArunC posted a topic in UltiMaker 3D printers,

        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
        MariMakes

        Picked By

        MariMakes,
      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...