Thank you very much for the response! I will definitely check Bridge out.Hi WXML,
I do not know anything about gyroids or anything. And I am no expert on nylon, but here is a couple things I have learned since I got my printer:
1) Nylon warps worse than ABS, in general, apparently.
2) 618 was one of Taulman's earliest versions. After that their Bridge nylon claims less warping and easier printing.
3) Have Bridge and it prints quite easily, but it still warps quite a bit, so use brims, glue, etc.
4) I have read on the forums here that 618 is quite hard to work with. Bridge is easier. But there are old forum poses about printing 618 specifically.
So, not super helpful, but hope it helps a bit. Good luck!
Recommended Posts
krys 206
Hi WXML,
I do not know anything about gyroids or anything. And I am no expert on nylon, but here is a couple things I have learned since I got my printer:
1) Nylon warps worse than ABS, in general, apparently.
2) 618 was one of Taulman's earliest versions. After that their Bridge nylon claims less warping and easier printing.
3) Have Bridge and it prints quite easily, but it still warps quite a bit, so use brims, glue, etc.
4) I have read on the forums here that 618 is quite hard to work with. Bridge is easier. But there are old forum poses about printing 618 specifically.
So, not super helpful, but hope it helps a bit. Good luck!
Link to post
Share on other sites