Jump to content
mechanicalmartin

saving profiles in Cura

Recommended Posts

Posted (edited) · saving profiles in Cura

When I save a profile in Cura it does not save the flow percentage.  Obviously I don't want to have to remember to enter that every time I use a printer.  How do I change this value permanently.  It is not a value in the json file.  So where do I make that adjustment? On further examination, it also changes the retraction values.

Edited by Guest

Share this post


Link to post
Share on other sites
Posted · saving profiles in Cura

With more experimentation, I have found that the software will save a profile and the settings can be viewed when you manage profiles... but when you select a given profile, the software always loads the current settings profile, never the profile you select.

Capture.thumb.PNG.3968c866b3400af9e7c78fa379713698.PNG

Capture.thumb.PNG.3968c866b3400af9e7c78fa379713698.PNG

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!