Good quality for Ultimaker UM2 PTFE

[paul9 20]

Afther two years old

[neotko 1,417]

It lasted 2 Years!? They are suppose to last 100h...

Since the sensor it's broken, the ptfe it's dead, you might want to move to TFM coupler (can print for 500-2000h)

https://ultimaker.com/en/resources/22188-how-to-replace-the-tfm-coupler

If you just want to buy another PTFE coupler and replace it:

http://support.3dverkstan.se/article/56-replacing-the-ptfe-coupler

Edited September 19, 2016 by Guest

[paul9 20]

It lasted 2 Years!? They are suppose to last 100h...

Since the sensor it's broken, the ptfe it's dead, you might want to move to TFM coupler (can print for 500-2000h)

https://ultimaker.com/en/resources/22188-how-to-replace-the-tfm-coupler

If you just want to buy another PTFE coupler and replace it:

http://support.3dverkstan.se/article/56-replacing-the-ptfe-coupler

 

These have replaced them by buying the kit for filaments from 1,75mm and PTFE and everything they needed directly from 3DSolex.

[neotko 1,417]

True, so you don't use that coupler you show, you use 1.75mm ones from 3dsolex.

Then I don't understand the topic...