Jump to content
Ultimaker Community of 3D Printing Experts
BucksLaserTech

Simplify 3D adhesive layer problems?

Recommended Posts

Desactivate the raft?

If you are new to 3d printing I suggest that you start with some tutorials about slicers to get the hang of the basic stuff. It will help you on the long run. Also S3D has a forum for that stuff and a lot of guides explaining every single option. I did expend quite a few months to fully use s3d And that was after learning how to use old cura.

So don't worry is an unavoidable learning curve.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Architect Design Contest | People
      The goal of this contest is to design a set of people figurines that could be used in such a project to make an area, office or mall seem populated. 
      Think of different types of people in different environments, like walking people, people standing still, working people, and both men and women.
       
      • 31 replies
    • Taking Advantage of DfAM
      This is a statement that’s often made about AM/3DP. I'll focus on the way DfAM can take advantage of some of the unique capabilities that AM and 3DP have to offer. I personally think that the use of AM/3DP for light-weighting is one of it’s most exciting possibilities and one that could play a key part in the sustainability of design and manufacturing in the future.
        • Like
      • 3 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!