Jump to content

Serious Bug in Ultimate software?


Snipper

Recommended Posts

Posted (edited) · Serious Bug in Ultimate software?

Is the following behavior of the Ultimate software (firmware) a Bug or my fault?

I had an sd-card in my Ultimate 2+,  which was printing from this card.

My UM is, by usb, connected to my computer which was not running.

By starting my computer the running UM restarted, interrupting and thereby ruining my print (the print process could not be resumed so I could throw away 5 hours printing).

This turned out to be a structural behavior of my Computer- UM combination.

Can anyone explain this or suggest a workaround?

(Other than disconnecting the UM before starting a print?)

PS

This turned out to be a structural behavior of my Computer- UM combination after restarting COMPUTER AND CURA

Edited by Guest
  • Link to post
    Share on other sites

    Posted · Serious Bug in Ultimate software?

    Is the following behavior of the Ultimate software (firmware) a Bug or my fault?

    AFAIK neither ... nor - it's the intended behavior.

    The new Cura automatically connects to the printer, if it is wired via usb. And the Arduino board resets itself as soon as it detects a serial connection.

    You don't need the usb connection if you print from sd card. The solution is indeed: remove the cable.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
    ×
    ×
    • Create New...