Willowflex- who has used and who has advice?

[Larum 1]

Hello,

I'd like to use Willowflex (http://bioinspiration.eu/willowflex-faqs/) with my Ultimaker 2+ but am not having any luck.

I'm using these settings:

Extruder-temperature: 175°

Printspeed: 50mm/s

Infill: 10%

Layer Height: 0.2mm

Anybody have any suggestions?

[neotko 1,417]

https://ultimaker.com/en/community/22080-fatiroberti-feeder-for-bondtech-dualdrive-175mm-cheap-kit?page=last#reply-153207

But I use a bondtech feeder made by me that uses the cheap DIY kit and 1.75mm

Anyhow it works

[Larum 1]

Anyone else printing with willowflex? using 3mm?

[Enno23 0]

On 10/24/2016 at 1:05 AM, Larum said:

Anyone else printing with willowflex? using 3mm?

Hello Larum,

 

did you find some good settings work for Willowflex?

Thanks,

Arno

Edited February 5, 2022 by Enno23