Jump to content
Ultimaker Community of 3D Printing Experts

Cura 2.3 and 2.1.3 on same computer ?


Spilz
 Share

Recommended Posts

Posted · Cura 2.3 and 2.1.3 on same computer ?

Hello,

Just a simple question,

is it possible to have Cura 2.1.3 and 2.3 on the same computer ?

(It was not possible with Cura 2.3 bêta )

The question is for Windows10 and for OSX

Thanks for your help

Regards

  • Link to post
    Share on other sites

    • Guest locked this topic
    Guest
    This topic is now closed to further replies.
     Share

    • Our picks

      • Ultimaker showcase | April 2022 | 4pm CEST | 10am EDT
        I'm excited because I've personally produced this showcase event, so if you are curious what else I'm up to nowadays, come check it out and say hi in the chat! It would mean a lot! 
          • Thanks
          • Like
        • 4 replies
      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...