Jump to content

curaengine RCF and RCP config files → current Cura Software: how?


scruss

Recommended Posts

Posted · curaengine RCF and RCP config files → current Cura Software: how?

I've just built a Reach 3D printer kit. It comes with curaengine filament and printer configuration files for use with Repetier Host. I'm not too familiar with Repetier, but have used Cura Software for a long time with a Printrbot, and I really like how the software works.

Is there a way to import these configs into Cura Software, please? The Reach 3D is a fairly standard Marlin-based open design. The config files are here: http://bit.do/reach3dprinter in the kickstarter reach 3d printer/cura config/Cura Settings Best folder. Any assistance greatly appreciated, thanks.

  • Link to post
    Share on other sites

    Posted · curaengine RCF and RCP config files → current Cura Software: how?

    It shouldn't be that hard, but I do think it's the responsibility of the people who made the printer to make a pull request for Cura to add their printers.

  • Link to post
    Share on other sites

    • 5 weeks later...
    Posted · curaengine RCF and RCP config files → current Cura Software: how?

    I've got a working configuration now for the Reach 3D and Cura Software. I've tested it printing via OctoPrint, and the results are as I'd expect.

    The Reach 3D uses a stock Marlin firmware, so it's easy to add to Cura Software. In the "Add New Printer" machine settings dialogue, set the following options:

    Maximum width (mm): 180

    Maximum depth (mm): 180

    Maximum height (mm): 150

    Heated bed: yes (if you have that option)

    Build area shape: Square

    GCode Flavour: RepRap (Marlin/Sprinter)

    If you've installed the E3D extruder (quite a popular option with Reach 3D owners), you'll probably want to knock the Maximum width setting down to around 170 mm. This depends on how much you had to shift the print bed to accommodate the shorter E3D extruder.

    A basic draft-quality PLA ini file for Cura Software is here: R3D-Generic_PLA_for_Cura_or_OctoPrint.ini

    This can also be imported into OctoPrint for use with its CuraEngine installation.

    All these settings were determined empirically, and have only been tested with Cura Software and CuraEngine 15.04 under Linux. Use at your own risk.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...