Jump to content

UM2+ at 935 € in Amazon ????


Recommended Posts

Posted · UM2+ at 935 € in Amazon ????

Be careful with shady Amazon "3rd party deals", it's been going through the IT press a few weeks ago. According to the media, it's hacked seller accounts being abused to scam people.

There are alot of 3d printers on Amazon.de atm that are usually more than 50% off. When you look at the name of the seller, it usually ends in "send email to xyz@mail.com before ordering". If you do so, you will get an email back that looks like it is from Amazon asking you to wire the money to some eastern europe bank account.

Needless to say: Chances are high you won't see your printer nor your money. If it's too good to be true and especially if they're trying to bypass amazon checkout, stay well away from it.

  • Link to post
    Share on other sites

    Guest
    This topic is now closed to further replies.
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 15 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
    ×
    ×
    • Create New...