I have tried this, and there is no image in browser. It worked fine the first week.
I have tried this, and there is no image in browser. It worked fine the first week.
There have been reports that USB cables were not seated properly, maybe something to check if that is the case for you?
I can check it, but today it suddenly works again.. 
-
1
-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
ahoeben 1,955
* find the ip address of your printer on the network
* in a browser, visit http://[printer ip address]:8080/?action=snapshot
If that does not show an image, there is something wrong on the printer; either the hardware or the software. I think the software side of the webcam is pretty robust, so my first guess would be that a cable might have come disconnected.
Link to post
Share on other sites