Under build plate adhesion select type as Brim. Use PLA from core 1 instead of PVA from core 2 for adhesion.
I tried that at first... PVA still prints inside the brim if I do that when I'm printing support. What about a raft of the first material? Or, what about this—what if there was a setting where everything on the first layer was a certain material (e.g. ABS), and then everything else after that would proceed as normal. Then, if you had a glass build plate, you could print the first layer in entirely PVA to make sure it sticks, then print whatever else you want after that. SandervG, what do you think?
Edited by Guest
Recommended Posts
benji_eod 0
Under build plate adhesion select type as Brim. Use PLA from core 1 instead of PVA from core 2 for adhesion.
Link to post
Share on other sites