UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I've used it and it worked well. I printed a squeeze bottle with TPU95A and PVA and didn't have any problems other than some PVA going astray and ending up in the wrong place and a bit of grinding on the PVA (not UMs brand, so that could've been a factor).
I've used it and it worked well. I printed a squeeze bottle with TPU95A and PVA and didn't have any problems other than some PVA going astray and ending up in the wrong place and a bit of grinding on the PVA (not UMs brand, so that could've been a factor).
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
IRobertI 521
I've used it and it worked well. I printed a squeeze bottle with TPU95A and PVA and didn't have any problems other than some PVA going astray and ending up in the wrong place and a bit of grinding on the PVA (not UMs brand, so that could've been a factor).
I printed using the recommendations found here:
https://ultimaker.com/en/resources/22235-how-to-print-with-ultimaker-tpu-95a
Link to post
Share on other sites
abesanity 0
Thanks for the reply, I will give it a shot. In a previous thread (https://ultimaker.com/en/community/33393-tpu-95a-filament-under-extursion) someone recommended using a lower fan speed for the UM3. Im not sure what model the OP had but I'll try a lower fan speed at first.
Link to post
Share on other sites