Jump to content
Ultimaker Community of 3D Printing Experts
devilflash

What could be the problem here?

Recommended Posts

Hi everyone,

I've got a problem during printing, you can see it on the pictures. When printing the lower layers, there is a problem of the alignment of the layers. It occurs only once on the print and the rest is flawless.

What could be the problem? What should I check?

I had to change the stepper motor from X axis but the motor from Y axis is fine.

Thanks for any suggestion!

uOWaW8y.jpg

Mo1fsdq.jpg

DF

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • How to 3D print with reinforced engineering materials
      Ultimaker is hosting a webinar where we explain how you can achieve and maintain a high print success rate using these new reinforced engineering materials. Learn from Ultimaker's Product Manager of Materials and top chemical engineer Bart van As how you can take your 3D printing to that next level.
      • 2 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!