Moin Gerd,
die Software muss bei uns vor dem Einsatz validiert weden.
Wenn Daten "nach Hause" gesendet werden, wird sie nicht genehmigt.
Mfg
Staudi
-
Our picks
-
New here? Get ahead with a free onboarding course
SandervG posted a topic in Official news,
Hi,
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.-
-
- 11 replies
Picked By
SandervG, -
-
Recommended Posts
zerspaner_gerd 324
Hallo Staudi,
Schau mal hier
Simplify3D Profile for Ultimaker 3 - Basic PLA/PLA (Work in progress)
Aber da ich Simplify3D kenne, glaube ich nicht dass das gleich auf Anhieb funktioniert!
Warum steht Cura nicht zur Verfügung?
Gruß Gerd
Link to post
Share on other sites