Cura 2.4 spiralize bug

[lance-greene 7]

so we have a printer we do a lot of vases on which was using cura 2.3 and had no problems with it. recently started using cura 2.4 on it and now when we do a spiralized vase on it it does a z hop at each new layer, which i entirely dont understand. retraction is turned off, retract on layer change is turned off, and z hop is turned off, yet it still does it.

oh and to make it even weirder, it z hops backwards......so it actually pushes the buildplate up into the hotend....wtf?

[burtoogle 509]

Known bug, set the outer wall wipe distance to 0 to stop it doing that.