Jump to content

Ultimaker 3 Filament detection wrong and to near to Headbed at Prints - but only on one side..!!!

Digibike

By Digibike
in UltiMaker 3D printers

 Share

Recommended Posts

Digibike

Digibike 107

Posted
Posted · Ultimaker 3 Filament detection wrong and to near to Headbed at Prints - but only on one side..!!!

Hi,

My Ultimaker 3 Extendend does not recognize the enclosed (chipped) filament rolls.

At least PLA I have tried and now as good as consumed.

The holder I have contacted, filament coil threaded and through this arm with the feedthrough for the filaments - but so it always came to jam during the transport - simply also the axis with the recognition cable works

It so far. Is there exactly for mounting / troubleshooting videos or more accurate documentation? Actually, it just fits so, but work is different ...

The other is that the nozzle "roughes" over the printing part. I do a scan before every print and still pulls you with partly in the ears aching noise over the printing parts. The distance is in my opinion much too small! Also on the pressure bed you can see that! I have printed a round part. He prints a half, the second half prints it after the 2nd or 3rd layer - before the distance is too low, so that no material can get out in the area ...

Interestingly with the same component 2 times printed, the first time the distance was left too small, the second time right?!?

I hope you can help me and give tips?!?

Best regards

Digibike

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...