What printer are you using and what material?
The first layer is printed typically slower and at a higher layer height them the preceding layers. So you may need to alter your speed or adjust the temp.
I'm using a ultimaker 2 and ultimaker pla.
I've tried slowing it down a bit but nothing changed, haven't tried adjusting the temp yet. I'm using the preconfigured normal quality printing from cura, How should I alter the temp and the speed?
Recommended Posts
Labern 775
What printer are you using and what material?
The first layer is printed typically slower and at a higher layer height them the preceding layers. So you may need to alter your speed or adjust the temp.
Link to post
Share on other sites