UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Cura by default prints the infill a bit too fast. I believe the idea is they assume you only care about infill for holding up the top surfaces and don't care about strength. If you care about strength just slow down the infill speeds.
Click on the gear and enable all the speeds. Set them all to the same speed (the slower speed). Well, leave the bottom or initial layer speed the same but fix all the infill and inner shell speeds the same as the outer shell speed.
1
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,230
Cura by default prints the infill a bit too fast. I believe the idea is they assume you only care about infill for holding up the top surfaces and don't care about strength. If you care about strength just slow down the infill speeds.
Click on the gear and enable all the speeds. Set them all to the same speed (the slower speed). Well, leave the bottom or initial layer speed the same but fix all the infill and inner shell speeds the same as the outer shell speed.
Link to post
Share on other sites