My Ultimaker 2 Go wont print what Cura gives it.

[DJJD 0]

This is my first time using Cura (version 2.5) and when I go to use the .gcode file for my Ultimaker 2 go it will state that it tried to print out of the printing zone, even though it was centered in cura.

Does anyone have an idea of how to fix this?

[fbrc8-erin 298]

It sounds like you're printing for an Ultimaker 2 instead of an Ultimaker 2Go. When you look in Cura at your model, what does the table cover behind it say? Ultimaker 2 or Ultimaker 2Go?

If it says anything other than Ultimaker 2Go, go back into the menu and select Ultimaker 2Go as your printer choice.