I have been looking thru Cura 2.6 and I cant find any setting to adjust speed while bridging.
I would think it would be possible during the sliceing calculations to determine when an area is going to be bridged much like when support is needed. Then call on the requested speed at that time.
I would like my bridge speed to be very low around 10mms while the rest of the print is running around 120mms - jerk settings, temp adjustments and even fan speed or off/on could also be tamed and adjusted to maximize successful bridging while not slowing down the entire print.
Just some thoughts
Recommended Posts
burtoogle 516
If that feature was available, I would use it. It would also be good if retractions & primes could, optionally, be made visible.
Link to post
Share on other sites