Large print troubles with cura

[Slinky 0]

Hi,

I'm having difficulty with Cura. I'm trying to print something 211 x 147 x 25 and despite the Ulti3 proclaimed print volume of 197x215x200 I cannot get it to fit so I can print it. It just says "unable to slice".

Is there a 'auto place' feature?

I've tried rotating every which way and I cannot find a printable placement despite being smaller than the advertised print volume and I cannot get it to print.

[gr5 2,269]

Build volume changes drastically depending on settings. For example you lose a lot in X if you have both nozzles in use. There's good advice here:

https://ultimaker.com/en/resources/44677-maximum-build-volume-ultimaker-2-plus-ultimaker-3