I edited the original post to include the photo. Is this correct or should I re-post?
- 2 weeks later...
That's very helpful. The lack of yellow is expected. Red is the outer most shell. Green is the next 3 shells. Yellow is anything not covered by those shells. Get it? it's exactly what you would expect.
Those small areas however don't look so good. It looks like probably underextrusion. Looking at the other settings I recommend you leave travel speed alone (or maybe increase to 150mm/sec) and then display ALL the speeds. Click on the gear and make them all visible. Then set them all to 30mm/sec. I know it will take almost twice as long to print but the quality should be significantly better and will probalby fix the underextrusion you are seeing.
If you want to do a quick test (I would want to) then I would click on the object to print in "normal view" and move it downwards under the bed until only those final areas to print are visible - maybe just the top 1cm of the part. Then print that as a test at 30mm/sec and it should look great.
Speed changes are bad on bowden printers as it can take quite a while for the pressure to balance out. And on these tiny little portions of the print it doesn't have time to equalize pressure. Lowering the speed helps a lot with this. If you really want to save time consider thicker layers but keep speed at 30 to 35mm/sec.
Recommended Posts
gr5 2,224
Please post a photo. While typing your text click on the image link second from right (image gallery) and then click on the "upload photos" tab.
Link to post
Share on other sites