Mine shows connected to the printer, and I can control bed preheat through Cura (I don't try printing to it because of the potential for problems though), but my problem is that every time I try to upgrade firmware, the printer reboots and Cura says the upgrade failed due to communications error. Does UM test for that functionality?
-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
nallath 1,123
I wouldn't recommend using USB printing. It will only add more points of failure, without giving you extra features.
We officially don't support USB printing for the UM2, so it's not something that gets a lot of attention when testing.
Link to post
Share on other sites