Thanks @gr5,
It was as simple as that.
I should have been more specific that this is an Ultimaker 2Go. So what I did was use the menu system to help me back out the filament as if I was doing a change. Once out I could see that on my filament role the gears had dug in just a little too much at their current position and must have been causing it to stick.
I cut off the filament just after that point, re-fed and it started printing as expected. Thanks for your help!
Recommended Posts
gr5 2,224
There's many possibilities. I'm going to go with "filament not quite reaching nozzle". And it's getting hung up somewhere inside the core. There's a few places where it can get stuck on an edge. So I would push down on the filament release lever on the extruder, then pull it all the way out and cut the tip of the filament into a point and then slide it back in again and when it stops, pull and push a few times to make sure it's all the way to the nozzle. That's my first guess.
Link to post
Share on other sites