Cura 2.6.2 Fill Viewing problem? And plot time error

[Mattee 0]

When I upload a model, Cura shows the bottom few layers as expected with a line fill only, doesn't matter which one you choose. Then as you move the slicer slider up...All you get is the outer most shell and a hollow interior, but no interior walls or infill, and that's exactly what prints. Also 0 - 95 % fill all say the same time (4-6 Hours). Infill ONLY shows if it's 100%, then the time jumps to day(s) for print time estimate... Any thoughts why this is happening? Solutions greatly appreciated.

Thanks Mattee

[nallath 1,124]

Could you share a project file with the model in it?