Jump to content

Extrusion


icewave

Recommended Posts

Hi guys I am haveing troble with my ultimater 2+ extruding filerment will seep out between the nozzle and the thing you screw it into and then it doesn't push out the right amount of filerment has anyone I can do I need to buy or do thanks Josh

  • Link to post
    Share on other sites

    Hi,

    Not sure i understood clearly your problem. But i seem to understand that some filament is leaking from the top of the nozzle where you screw it too the block?

    If so, then you need to tighten the nozzle a bit more, heat the nozzle to at least 140 - 160°c and tighten it more. After that you need to relevel the bed most probably.

    Always change the nozzle while hot.

    I advise you to print the torque wrench that you can find on youmagine

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 3 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...