It depends how you want to go about the feeder motor at the back. Leave only one there or add another one on the right side?
If you use only one then I would create two different machines in Cura 2.x and use either when you want to print with different filament diameters.
This is essentially what I plan to do. I am thinking about cutting the heater block and heat sensor cables and using screw terminals to easily switch nozzles without messing with the motherboard every time. Any tips on how to do this? I don't want to mess up my new components...
Recommended Posts
Nicolinux 288
It depends how you want to go about the feeder motor at the back. Leave only one there or add another one on the right side?
If you use only one then I would create two different machines in Cura 2.x and use either when you want to print with different filament diameters.
Link to post
Share on other sites