Jump to content
Ultimaker Community of 3D Printing Experts

Active leveling on UM3 fails to initiate after a print job is prematurely cancelled

Recommended Posts

I've noticed that on a new UM3 with the latest firmware, if I cancel a print job (either through Cura 2.7 or on the UM3's command dial) then the next job will not have active leveling initiated at its beginning. Is this a known issue?

I'm new to the forum and apologize if this is already an actively tracked topic/bug.


Edited by Guest

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!