UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
My bad, I feel very stupid, I found the solution 5 minutes after posting: the screws on the z-axis coupler were untightened, so the coupler was a bit loose and the axis was not turning correctly, resulting in Z value getting off slowly. I found by playing with the ulticontroller, noticing that when I set the z-axis to 0.0, it was off, then hitting home (relying on end switches) it was fine, then playing with th z axis again, it was getting more and more off.
Man, when I think I have made every possible mistake and that now it's gonna be ok, I always find new ones
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
olivierc 3
My bad, I feel very stupid, I found the solution 5 minutes after posting: the screws on the z-axis coupler were untightened, so the coupler was a bit loose and the axis was not turning correctly, resulting in Z value getting off slowly. I found by playing with the ulticontroller, noticing that when I set the z-axis to 0.0, it was off, then hitting home (relying on end switches) it was fine, then playing with th z axis again, it was getting more and more off.
Man, when I think I have made every possible mistake and that now it's gonna be ok, I always find new ones
Link to post
Share on other sites