Jump to content

Custom start/end gcode for material profile

raptwa

By raptwa
in UltiMaker Cura

 Share

Recommended Posts

raptwa

raptwa 0

Posted
Posted · Custom start/end gcode for material profile

Hello,

In the current version it is possible to add a custom start/end gcode for each printer profile. It would be very useful, if this also would be possible for each materials profile. For example it would be possible to modify custom settings, which are material dependent, like the K factor for "linear advance" in the marlin firmware.

Thnaks in advance!

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...