Hello everyone,
Yes, you can use any open source software with NEVA. You can find all that information at the NEVA user group on Facebook.
Cheers!
DidierKlein 729
Also if im not wrong they give a version of old cura that is preconfigured for the neva. You can basically get the information from there and insert them in the new cura.
Im not familiar with the neva facebook groups but on the cr10 group for example you can find profiles for the new cura also as mentioned before
-
Our picks
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
UltiMaker Cura 5.9 stable released!
ArunC posted a topic in UltiMaker Cura,
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more-
-
- 5 replies
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 4 replies
Picked By
MariMakes, -
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
Recommended Posts
BronzePrint 0
Ive been looking for the same thing. I would like to use the regular Cura instead of the simplified Neva build.
Link to post
Share on other sites