Cura Connect doesn't need authentication.
So everybody inside my LAN can just start/stop prints?
Seems to be a little bit inconsequent. When Cura Connect doesn't need it, why did you implement it in general?
But back to my original question. Can I get some information who starts a job?
Recommended Posts
korny86 0
I figured out that an other colleague of mine has an Ultimaker 3, too. And to any reason the job starts on the wrong printer. This is very strange and I expected that every user has to get access (by pressing the button in the frontpanel of the printer) before printing is possible.
Anybody else with more then one UM3 has the same problem?
Link to post
Share on other sites