Jump to content

auto level - 3 points - before/after firmware update

diederik

By diederik
in Improve your 3D prints

 Share

Recommended Posts

diederik

diederik 0

Posted
Posted · auto level - 3 points - before/after firmware update

Hi

 

This afternoon I did a firmware update to the Ultimaker 3 I am borrowing. 

 

Before the update, when auto-levelling, the printer choose 2 points in the front (one left, one right) and one in the back (in the middle).

 

After the update, I notice the printer chooses two ponts on the left (on in the front and one in the back) and one on the right (in the middle). 

 

Why ? Is it possible to change this, or to use 4 points ?

 

Kind regards

Diederik

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...