Jump to content

Setting of an intro line


Craos

Recommended Posts

Posted · Setting of an intro line

I use Prusa MK2 MultiMaterial printer. Longer filament extrusion is required in comparison with standard Prusa Mk2 on the beginning of the printing as filament goes slightly longer way and previous color needs to be cleaned. When I use Slic3r Prusa Edition, it makes intro line ( I hope it's correct word - see the attached photo for what I mean ) very long and very huge. Cura generates it short and tine ( it's on the picture ). Is there a way, how to setup the intro line in Cura?

introline.png

  • Link to post
    Share on other sites

    Posted · Setting of an intro line

    This is not answer to my question, but it's workaround, which can help to somebody. There are 2 lines at beginning of the generated GCODE, which have "intro_line" remark attached. In case these lines are replaced with this code:

     

    M83 ; relative extrusion mode
    G1 Z0.250 F7200.000
    G1 X50.0 E80.0  F1000.0
    G1 X160.0 E20.0  F1000.0
    G1 Z0.200 F7200.000
    G1 X220.0 E13 F1000.0
    G1 X240.0 E0 F1000.0
    G1 E-4 F1000.0 
    M82 ; absolute extrusion mode

     

    it works fine.

     

     

  • Link to post
    Share on other sites

    Posted · Setting of an intro line

    If I am reading you correctly then I think telling Cura to print a skirt is your answer. It is configurable so you can make it as long as you  want to. The setting is located in the Build Plate Adhesion  group.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...