Jump to content

First layer using cura 3.1 in Repetier-Host


Don Elliott

Recommended Posts

Posted · First layer using cura 3.1 in Repetier-Host

I'm using cura 3.1 in Repetier-Host and my question is if I increase the first layer in cura slicer, The height is correct to what I tell it to be but the fulfillment feed rate increase very fast layer than on the 2nd layer it slows back down to where it's set at. What is going on??Is this something in cura it self or something I'm doing wrong????

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...