This is a known bug in cura 3.1.0. Fixed supposedly in older or newer versions. Certainly in the 3.2 beta this should be fixed. It doesn't affect Ultimaker printers so the bug wasn't caught I suppopse in QA.
I have the same problem, time to try the Beta version then!
Recommended Posts
zaniix 0
I have this same exact issue in Cura 3.1.0. No matter what values I put into all the extruder temp fields and yes I changed all of them, it still outputs 210 into Gcode, see below ( and yes bed was set at zero on purpose) It changes to the correct temp much later in the gcode. I do not understand what is going on
M104 S210 ; set extruder temp
M140 S0.0 ; set bed temp
M190 S0.0 ; wait for bed temp
M109 S210 ; wait for extruder temp
Link to post
Share on other sites