On "Tree", that's what I get, the only option is to add more walls.
Even on regular support, I didn't get as much as I would like, I got a grid under my "zig-zag" support, but I'd like some inflation distance. Adding a Brim everywhere can lead to an ugly part, but looking at these little supports, you can see the huge lever arm they have to pry themselves off the bed with only a couple lines of adhesion.
I've used a similar feature with other slicers and I can tell you from experience it can really save your bacon.
Recommended Posts
Brulti 177
Why is there no infill on your supports in this picture? Infill gives some stability to the supports, much more than if it is just a simple wall.
Link to post
Share on other sites