kmanstudios 1,120
I think I must be getting old. I am not sure what you mean, and the pics do not look too bad to me. I am actually not sure what the error would be.......
I think I must be getting old. I am not sure what you mean, and the pics do not look too bad to me. I am actually not sure what the error would be.......
Is it ultimaker pva? If yes print temp is around 225°c
Alos like kman i'm not sure to understand from the pics what is going wrong
Recommended Posts
Mónica 0
layer height: 0.1 mm
temperature: 200ºC
print speed: 30 mm/s
at first the printing speed I used was 60 mm/s but it's the same thing.
Link to post
Share on other sites