Jump to content
Ultimaker Community of 3D Printing Experts
WowaWie

UMO+ Extendet (Z:300mm) druck nur bis 210mm

Recommended Posts

Guten Morgen,

Ich habe meinen alten UMO+ zu einem Extendet umgebaut. Druckhöhe 300

Seit paar Tagen versuche ich ein Bauteil mit 300mm höhe zu drucken, leider Ohne Erfolg.

 

Obwohl ich bei den Einstellungen in Cura auf Z: 300mm umgestellt habe bleibt das Druckbett bei ca. 205-210 mm stehen.

 

Ich denke mal dass er das eigentlich übernehmen muss oder ist es bei dem Ultimaker 2 Motherboard so dass

es zusätzlich in der Firmware verändert werden muss??

 

Wäre echt super wenn mir jemand helfen könnte.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 122 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!