-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
greens83 5
After much deliberation and noticing that the PLA was coming out of the nozzle at a slight angle I decided there was a partial clog right at the tip of the nozzle which I had not been able to remove in my previous attempt to clear the hot end of any blockages. I heated the hot end up, removed the nozzle(apparently you should not try to remove the nozzle cold as it can shear off) and cleaned it out by using a lighter to completely burn out anything in the nozzle, there was a little smoke which leads me to believe there may have been a tiny bit of plywood or something flammable in there. I washed the nozzle and removed the soot with some wire wool (cleaning again and blowing out any particles).
HURRAY ! the ultimaker is now back to the quality I'm used to. Thanks everyone for their input, I hope this helps someone else.
Link to post
Share on other sites