Thank you for your suggestion.
The z stepper is set to 1/8 as explained in [1]. I allready thought about swiching to 1/16 to fix this but then it would be broken with ReplicatorG / Skeinforge an I hoped (and still hope) there is a software setting for this.
Recommended Posts
owen 19
I think there is a jumper to tell it to be 8 step and not 16 step or similar on the Arduino board which could be missing missing or there's an open circuit. Or it shouldn't be there and it is or there's a short. Someone who knows will chime in soon. Not sure why it's OK in Skienforge but there may be a software setting there for the 16 step.
Link to post
Share on other sites