Next time if this happens, please check if restarting Cura works to get the state right. If it doesn’t, that means OctoPrint is still telling Cura it is not ready.
- 3 weeks later...
Sorry for the delay in following up. Restarting Cura does not reliably connect to Octoprint. It seems to be a lottery about when and whether it will work.
[Edit] I've noticed that sometimes if I wait a while (minutes) it will eventually connect. In addition, once it has connected, it will sometimes say "Sending data to Octoprint" but show now progress until I click cancel and try again.
One more thing: sometimes after a print, the Octoprint web interface claims the print has finished, but Cura thinks it has not, and so does not allow another print to start. All this implies to me that the comment in the previous post (Octoprint is still telling Cura it is not ready) sound like it is the case.
Edited by DavidEl
Not sure if anyone is still reading this thread, but for the record, I suspect the problem was with the OctoPrint instance. I did a fresh install and on a small number of test prints have not seen a problem. It may be that one of plugins I use in OctoPrint was the cause - I've not yet reinstalled all of them.
- 1
Recommended Posts
Adam324 13
I use Octopi 0.3.1 with Octoprint 1.3.8 and haven't noticed that yet. So far it has been working just fine for me. I see Octoprint 1.3.9 was released 3 days ago but I haven't upgraded to that yet but I plan to.
I am not sure if I leave the Monitor screen up though all the time as I am usually flipping back to the Prepare screen to get ready for the next print.
Edited by Adam324Link to post
Share on other sites