Jump to content

Recommended Posts

Posted · ULTIMAKER in Enterprise Level WLAN and LAN

Hi there

I would like to get our ULTIMAKER 3 connecting to our Enterprise Level WLAN and LAN. Therefore I would need to know the MAC address because this is what is used for making a device visible in the university internal network space (MAC address for WLAN and LAN adapter). The MAC I have to send to our IT department.

After the MAC is registered I can connect to our network. 

The other question is if enterprise level stack is available on ULTIMAKER 3

 

Regards and thaks for answer.

Harald Sattmann

  • Link to post
    Share on other sites

    Posted · ULTIMAKER in Enterprise Level WLAN and LAN

    Are you in a position to setup the UM3 on your own LAN?  If so, connect the UM3 to a router, both wired and wireless.  Put your laptop or PC on the same network.  Assuming you're running linux, run:

    sudo nmap -sP 192.168.1.0/24

    where 192.168.1.0 is the actual is the subnet and /24 is the actual mask.  You should see a report of all devices connected to that network.  Look for hostnames that have Ultimaker in them.  You should see the MAC addresses of the interfaces of all the hosts on the network.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.9 stable released!
        Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements.  Check out the rest of this article to find out the details on all of that and more
          • Like
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Heart
          • Thanks
          • Like
        • 4 replies
    ×
    ×
    • Create New...