Hallo Nico,
ich habe jetzt versucht die Messingdüse abzuschrauben. Dabei ist der Druckkopft unterhalb der Kühlrippen gebrochen.
: (
Hallo Nico,
ich habe jetzt versucht die Messingdüse abzuschrauben. Dabei ist der Druckkopft unterhalb der Kühlrippen gebrochen.
: (
Verdammt, ja die Printcores sind da sehr empfindlich. Auseinander bauen ist gefährlich. Ich dachte du würdest die Printcore erneut erhitzen und versuchen von oben das Material herauszufischen. Sorry dass es dabei kaputt gegangen ist.
Kann man überhaupt bei den originalen UM Printcores die Nozzle abschrauben?
Oder handelt es sich um 3dsolex Printcores?
Bei den original Printcores lässt sich die Nozzle nicht abschrauben.
Doch man kann die Messingdüse abschrauben. Man bekommt sie aber nicht mehr richtig drauf. Ich denke das ist eine Sollbruchstelle.
Recommended Posts
Nicolinux 288
Hi,
Ich weiss nicht was du mit dem silbernen Röhrchen meinst (die Oberseite des Print Cores?). Auf jeden Fall musst du erstmal das abgebrochene Stück Filament entfernen.
Schau dir das an:
https://ultimaker.com/en/resources/23132-clean-the-print-cores
Wenn du magst, poste auch ein Foto vom aktuellen Stand, dann können wir genauere Tipps geben.
Link to post
Share on other sites