mastory 31 Posted February 19, 2012 in Netfabb profiles I believe I corrupted one of my netfabb material profiles. Is there someplace I can download the profiles that came with my software installation (recent). I believe these are credited to have been developed by Paul Candler and Florian Horsch. Is there a means to reset them to their 'defaults'? Not sure that defaults exist for the profiles... Should I just re-install? I have only just tried (unsuccessfully so far) to use the software. Also, I think I read there is a new release just around the corner. Thanks, Matt Share this post Link to post Share on other sites
ddurant 0 Posted February 19, 2012 in Netfabb profiles Have you tried the Reset Machine Settings button in the Machine tab on the lower/right? You'll have to click on Ultimaker on the top/right to get the Machine tab to show up. That should reset stuff back to the defaults. Share this post Link to post Share on other sites
mastory 31 Posted February 20, 2012 in Netfabb profiles Thanks, worked great. Share this post Link to post Share on other sites