Jump to content
Ultimaker Community of 3D Printing Experts

First layer support missing


rebekah_harper
 Share

Recommended Posts

Posted · First layer support missing

Hiya,

 

I was wonder why when I have ext1 set for brim, that the first layer for the support on ext2 gets printed after layer 2 of ext1.

In effect it misses the bottom layer of the support. this causes adhesion to build plate issues. 

 

many thanks 

 

Rebekah 

  • Link to post
    Share on other sites

    • 2 months later...
    • 5 months later...

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    ×
    ×
    • Create New...