Jump to content
MaxMax

Ultimaker 3 Autoleveling fails epic...

Recommended Posts

Posted (edited) · Ultimaker 3 Autoleveling fails epic...

After the autolevel process my first layer looks like this:

 

20181005_033307.thumb.jpg.d2a456691c1cedb3829fb7c076ef6417.jpg

 

The heatbed is so close to the nozzle that almost nothing comes out and get compressed, then when the Z compensates it pours out.

Is there a way to calibrate the autocalibration? Or just fix it so it works?

 

EDIT:

Here is the second layer. Heatbed still too close (look at the bottom part of the picture.

 

20181005_035722.thumb.jpg.2c21f969686a0ee420e13f1a256f5734.jpg

 

(The heatbed is just cleaned and laying flat).

Edited by MaxMax

Share this post


Link to post
Share on other sites
Posted · Ultimaker 3 Autoleveling fails epic...

Check this thread and measure your distance and if the nozzles are clean.

 

 

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...