Ultimaker 3 Autoleveling fails epic...

[MaxMax 0]

After the autolevel process my first layer looks like this:

 

 

The heatbed is so close to the nozzle that almost nothing comes out and get compressed, then when the Z compensates it pours out.

Is there a way to calibrate the autocalibration? Or just fix it so it works?

 

EDIT:

Here is the second layer. Heatbed still too close (look at the bottom part of the picture.

 

 

(The heatbed is just cleaned and laying flat).

Edited October 5, 2018 by MaxMax

[Smithy 1,145]

Check this thread and measure your distance and if the nozzles are clean.